COVID-19 updates
, Makeup.jpg, Hospitality_0.jpg, Music-7.jpg, , Dental.jpg
Home | Courses | Restricted - Attachment of cords/cables and plugs to low voltage three phase electrical equipment

UEESS00092 Restricted - Attachment of cords/cables and plugs to low voltage three phase electrical equipment

National ID: UEESS00092 | State ID: AC311

Three phase plug and cord replacement

Successful completion of this skill set will equip you with the tools you need to be able to attach cords, cables and plugs. You'll gain the training, skills and knowledge to change a flexible plug or cord and wire up new plugs and sockets.

You'll cover the following units:

UEENEEE101A Apply occupational health and safety regulations, codes and practices in the workplace
UEENEEP024A Attach cords and plugs to electrical equipment for connection to a single phase 230 volt supply
UEENEEP025A Attach cords, cables and plugs to electrical equipment for connection to 1000 Va.c. or 1500 Vd.c. supply

Enabling you to:

  • Select flexible cords/cables and plugs to suitapplications
  • Connect flexible cords/cables and plugs
  • Perform testing procedures
  • Locate and repair faults in flexible cords and plugs
  • Provide reports

Please note course duration is one and a half days, (day 1, 8:30am - 4:30pm; day 2, 8:30am - 11:30am) and classes are run subject to numbers - refer to How to apply for more information. Minimum course numbers 5, maximum 12.


How to apply


Please note that a current First Aid Certificate is a pre-requisite for this skill set and you will be asked to provide a copy of your certifciate at registration.

How to apply

If the skill set you wish to apply for is not listed in this application form, classes may have been filled, or scheduling for the next intake may not have commenced. Please check back later.

Delivery location, important dates and study options

During your course of study, NMTAFE may use a variety of learning practices to ensure you get the best outcome for your learning journey.
This may include online learning, face-to-face classroom, laboratory/workshop delivery, work placement or a combination of these, depending on which is most appropriate.

This course is currently undergoing delivery planning and information will be available on our website shortly. Check back later, or use the course enquiry form below to have our Client Contact Centre contact you with further information about the next course start, delivery locations and study modes.

Course enquiry

Please note This form is only for course enquiries. If you would like to apply, please refer to the 'How to apply' tab above.

Page last updated September 04, 2020